Ultrasonic and nelson conversion?

Go down

Ultrasonic and nelson conversion?

Post by JoeW on Sat Oct 27, 2018 6:16 pm

Any reason(s) I can't use my Hornady ultrasonic cleaner to clean my nelson conversion?

JoeW

Posts : 89
Join date : 2015-04-01

Back to top Go down

Re: Ultrasonic and nelson conversion?

Post by zanemoseley on Sat Oct 27, 2018 6:29 pm

Should be easy enough as long as you fully strip it. I wouldn't run the slide while its assembled as you'll trap fluid in the firing pin housing.

zanemoseley

Posts : 928
Join date : 2015-07-11

Back to top Go down

Re: Ultrasonic and nelson conversion?

Post by LenV on Sat Oct 27, 2018 6:57 pm

I ran some blued moon clips in mine. Now they are white moon clips. May work great. Might not.

Len
avatar
LenV

Posts : 3220
Join date : 2014-01-24
Age : 68
Location : Oregon

Back to top Go down

Re: Ultrasonic and nelson conversion?

Post by fc60 on Sat Oct 27, 2018 7:42 pm

Greetings,

Make sure the cleaning fluid is not going to react with any of the metal parts.

Also, ultrasonic waves create cracks in hard anodized Aluminum if you leave it in too long.

A great way to clean; but, the ultrasonic waves can be destructive.

Cheers,

Dave
avatar
fc60

Posts : 427
Join date : 2011-06-11
Location : South Prairie, WA 98385

Back to top Go down

Re: Ultrasonic and nelson conversion?

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum