Turning Target Controller

Go down

Turning Target Controller

Post by gburns51 on Mon Jun 03, 2013 6:51 am

Need help finding someone to repair a non-functioning turning target controller or in the alternative replacing the controller. The non-functioning controller was built by Frank Thomas somewhere in TN.


gburns51

Posts : 1
Join date : 2013-06-03

Back to top Go down

Re: Turning Target Controller

Post by DavidR on Mon Jun 03, 2013 10:31 am

Ed Hall, designed a turner built from a car wiper motor, maybe he will answer and give details.
avatar
DavidR
Admin

Posts : 3016
Join date : 2011-06-10
Age : 64
Location : NRA:Expert, Georgia

Back to top Go down

Re: Turning Target Controller

Post by Ed Hall on Tue Jun 04, 2013 7:58 am

I have repaired a couple of these many years ago, but it took me a bit to figure out the circuitry. I'm sure I don't remember much from those repairs and would need to start pretty much from scratch. I believe there was an individual that officially took over from Thomas, but that was long ago, as well. I'm sure I could come up with a repair, but I am quite slow with everything these days, so it would take a while. If you are not in a big hurry and are going to Camp Perry, it might be best to bring it to me there and I can look at it then, if you haven't gotten it fixed by Nationals.

Ed Hall

Posts : 598
Join date : 2012-09-10
Location : Adirondack Mountains

http://www.starreloaders.com/edhall/

Back to top Go down

Re: Turning Target Controller

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum