Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Remington HBWC COL measurement

3 posters

Go down

Remington HBWC COL measurement Empty Remington HBWC COL measurement

Post by orpheoet 3/19/2018, 1:20 pm

I finally got around to loading some of these and noticed that because of the profile of the bullets face I get a slightly longer COL however it measures the same as Zero's at the edge(1.155") If I used a flat seating die the projectile would actually be noticeably lower than the edge of the case. Continue to seat on the edge of the bullet? I have Star's, Zero's. and Remington all loaded exactly the same. Should be a good experiment.
orpheoet
orpheoet

Posts : 1050
Join date : 2014-07-29
Age : 56
Location : Berea, Oh

Back to top Go down

Remington HBWC COL measurement Empty Re: Remington HBWC COL measurement

Post by desben 3/19/2018, 2:28 pm

I myself leave a fingernail's thickness worth of lead sticking out. Gives the crimp something to hold, or something like that.
desben
desben

Posts : 384
Join date : 2013-12-22
Location : Ontario, Canada

Back to top Go down

Remington HBWC COL measurement Empty Re: Remington HBWC COL measurement

Post by cdrt 3/19/2018, 4:54 pm

If you look at Remington factory rounds, they seat the bullet so there is a tiny amount of brass showing on the inside edge of the case.   That's how I load them using a taper or roll crimp, depending on which pistol they are being fired from.
cdrt
cdrt

Posts : 822
Join date : 2016-04-12
Location : Amarillo, Texas

Back to top Go down

Remington HBWC COL measurement Empty Re: Remington HBWC COL measurement

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum