Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Taurus and Nelson?

4 posters

Go down

Taurus and Nelson?  Empty Taurus and Nelson?

Post by Tim:H11 10/26/2016, 1:48 pm

I have a Taurus 9mm frame available to use and I'm thinking of making it the dedicated lower for my Nelson. Not fond of Taurus personally but the question is -

Will it work? What are some issues I may find?
Tim:H11
Tim:H11

Posts : 2119
Join date : 2015-11-04
Age : 35
Location : Midland, GA

Back to top Go down

Taurus and Nelson?  Empty Re: Taurus and Nelson?

Post by Chris Miceli 10/26/2016, 2:18 pm

from marvel precision... I imagine same applies for Nelsons.

We do know, our Conversion Units will not fit on the models listed below:
Beretta
Glock
Browning
Bull M-5
Taurus PT92
SIGS



can always try 

Chris Miceli

Posts : 2715
Join date : 2015-10-27
Location : Northern Virginia

Back to top Go down

Taurus and Nelson?  Empty Re: Taurus and Nelson?

Post by STEVE SAMELAK 10/26/2016, 2:27 pm

Doesn't necessarily apply in this instance...the PT 92 is a version of the Berreta 92 not a 1911 clone.

MIGHT work
STEVE SAMELAK
STEVE SAMELAK

Posts : 934
Join date : 2011-06-10

Back to top Go down

Taurus and Nelson?  Empty Re: Taurus and Nelson?

Post by Sc0 10/29/2016, 11:24 am

Converted a .45 PT1911 to a dedicated Nelson. Works fine but would replace the springs, pins, 80-series delete plate, and for me I replaced the safety as the ambi safety was annoying. The Taurus frame seems to be a wee bit soft in the Rc department imho, and the internals especially the springs are not very good. (Drilled holes start to peen around the edges, pins start to show wear, etc.) For a .22 upper it works out to be ok though, the frame rails are long and stick out past the Nelson slide by about .1 or .2" but doesn't affect functioning. I do have marks on my sight rib, evidence that the top of a hammer hit it but since then I replaced it with a KC Battleaxe and no more issues. Cannot remember if the Taurus hammer hit it or my RO hammer did it...

Sc0

Posts : 303
Join date : 2013-12-29
Location : Houston, TX

Back to top Go down

Taurus and Nelson?  Empty Re: Taurus and Nelson?

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum