DIY gunsmith job tonight

Page 2 of 2 Previous  1, 2

View previous topic View next topic Go down

DIY gunsmith job tonight

Post by Magload on 4/20/2017, 6:12 pm

First topic message reminder :

Wish me luck I am about to change out the sear spring and main spring in the 52-2 I just bought.  Trigger is breaking at 1lb 13oz and I am hoping for 13oz more to be on the safe side of 2.5lbs.  Don
avatar
Magload

Posts : 840
Join date : 2016-11-18
Age : 70
Location : NE Florida

Back to top Go down


Re: DIY gunsmith job tonight

Post by LenV on 4/23/2017, 8:02 pm

All of that looks like more work then needed. I would put a spring over the over travel screw that compressed when I pulled the trigger. It would stay in place because it would be captured by screw and compression. But I have a lot of Redneck in me.

avatar
LenV

Posts : 2409
Join date : 2014-01-24
Age : 67
Location : Oargun

Back to top Go down

Re: DIY gunsmith job tonight

Post by Magload on 4/23/2017, 8:12 pm

LenV wrote:All of that looks like more work then needed. I would put a spring over the over travel screw that compressed when I pulled the trigger. It would stay in place because it would be captured by screw and compression. But I have a lot of Redneck in me.


Redneck?  I'm Redneck, white socks and Blue Ribbon beer.  You know that could be a fix and I could duct tape it in place.  Don
avatar
Magload

Posts : 840
Join date : 2016-11-18
Age : 70
Location : NE Florida

Back to top Go down

Re: DIY gunsmith job tonight

Post by Sponsored content


Sponsored content


Back to top Go down

Page 2 of 2 Previous  1, 2

View previous topic View next topic Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum