Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Hammer falling to half cock

3 posters

Go down

Hammer falling to half cock Empty Hammer falling to half cock

Post by davekp Sun May 28, 2017 4:57 pm

Suddenly, the hammer on my 22 conversion started falling to the half cock position after firing. Trigger is between 2-1/2 and 2-3/4 lbs. Disconnector spring is set at 16 oz. Too light? Or something else?

davekp

Posts : 315
Join date : 2011-06-11

Back to top Go down

Hammer falling to half cock Empty Re: Hammer falling to half cock

Post by jglenn21 Sun May 28, 2017 7:12 pm

16 oz should be ok if you have everything smooth..

back your trigger stop out a half turn or so.. Also if you have set the pre travel to be tight turn the tab back to allow more pretravel. you need at least .025 pretravel.


if those fail to fix it make sure the disconnector is clearing the sear legs when the slide pushes it down
jglenn21
jglenn21

Posts : 2567
Join date : 2015-04-07
Age : 75
Location : monroe , ga

Back to top Go down

Hammer falling to half cock Empty Re: Hammer falling to half cock

Post by Tim:H11 Sun May 28, 2017 7:30 pm

+1 check your over travel stop. 16 ounces should be enough. I personally prefer 1.25 pounds just for peace of mind.
Tim:H11
Tim:H11

Posts : 2119
Join date : 2015-11-04
Age : 35
Location : Midland, GA

Back to top Go down

Hammer falling to half cock Empty Re: Hammer falling to half cock

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum