Yup did it again a little boo boo

Go down

Yup did it again a little boo boo

Post by Froneck on 6/22/2017, 12:19 am

Been making a pile of shoes. One ring was made with a smaller outside diameter so that the groove is not as deep and therefore able to work on a short trigger. When doing that I must change the coordinates of the set screw holes. When setting one in the Jig borer I use to put in the set screw holes I put in the one with the smaller OD, when I brought the drill to the surface I seen my mistake but too late and put a slight drill point mark on the surface. Shoe is the type for solid trigger, Standard width (17/32"), outside diameter was reduced .060" so it will fit any trigger but intended for a short trigger. Error drill hole is nothing more than what looks like a slight center punch mark. So here is another shoe in the condition that will need the ends rounded for $20, want me to mill the corners rounded yet you finish it $25 or I finish it and ready to install $35. Any version of the will come with the set screw and hex wrench and shipping included.

Froneck

Posts : 869
Join date : 2014-04-05
Age : 71

Back to top Go down

Re: Yup did it again a little boo boo

Post by Ghillieman on 6/22/2017, 2:35 am

I'll take it for $20, send you a PM.
avatar
Ghillieman

Posts : 409
Join date : 2012-02-14
Location : TEXAS

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum