Slight oops trigger shoe SOLD

Go down

Slight oops trigger shoe SOLD

Post by Froneck on 8/8/2017, 9:57 am

While making a few standard width (17/32") Al. Bronze shoes for trigger with 3 holes I bumped the edge with the cutter. Set it aside and completed the other 3 I cut from the ring. Another shoe was ordered so I picked up the shoe with the slight nick in the corner and completed it before noticing that it was the one I set aside. Nick is small and could probably pass as a good shoe but I know it ain't!  You will have to look close to see the error, slight nick on the outside edge of the set screw side. (top edge of right hand shooter) Nick is only on the outside edge does not continue to the trigger slot.
 I currently sell this shoe for $50, I used up all of the bronze bar I had so the price will have to go up since the cost of the bronze went up. Here's your chance to get a shoe with 4 set screws designed to fit a trigger with 3 holes but will work on a solid trigger also. Complete, ready to install and nothing to do to it for $30
Frank


Last edited by Froneck on 8/8/2017, 9:37 pm; edited 1 time in total

Froneck

Posts : 869
Join date : 2014-04-05
Age : 71

Back to top Go down

Re: Slight oops trigger shoe SOLD

Post by Rotwang on 8/8/2017, 3:50 pm

I'll take it.

PM sent.

Rotwang

Posts : 21
Join date : 2011-06-23

Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum