Pardini Question

Go down

Pardini Question Empty Pardini Question

Post by Nickster on 12/25/2019, 6:35 pm

I have Pardini SP New probably 12 years old that has part number #703/R Counter-Weight Ries Locking Pin. I dont know how to describe it except that the screw that holds the counter weight and barrel onto the frame goes into it. It actually screws into the frame also and it has been coming loose. Should I loctite this part into the frame? Would that be a problem down the road? Thanks in advance.

Steve

Nickster

Posts : 4
Join date : 2011-06-11

Back to top Go down

Pardini Question Empty Re: Pardini Question

Post by fc60 on 12/25/2019, 7:17 pm

Greetings,

You need to telephone Vladimir at PardiniUSA.

Cheers,

Dave
fc60
fc60

Posts : 734
Join date : 2011-06-11
Location : South Prairie, WA 98385

Back to top Go down

Pardini Question Empty Re: Pardini Question

Post by CrankyThunder on 12/26/2019, 5:25 pm

I would call Vlad as well but I would not hesitate to use locktite, the low strength stuff to begin with. 

Regards, 
Crankster
CrankyThunder
CrankyThunder

Posts : 208
Join date : 2012-03-03
Age : 60
Location : Burrokratic republik of Michigan, Cubicle LVW-2a19d, Rock #3

http://www.ccrcpistolteam.weebly.com

Back to top Go down

Pardini Question Empty Re: Pardini Question

Post by Nickster on 12/27/2019, 1:06 pm

Well I tried the number on their website but it is not in service. Much the same as just about everyone else these days. Anyway, I emailed them the same question and their response was that they do use temporary loctite but it’s better if they do it. I’m not actually not all that far from Tampa so I might make a day trip and get it completely seviced by them.

Nickster

Posts : 4
Join date : 2011-06-11

Back to top Go down

Pardini Question Empty Re: Pardini Question

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum