David Sams 92fs question
4 posters
David Sams 92fs question
Hi all,
I was hoping for a little help. I recently acquired a Beretta 92fs built by David, my question is does the cone at the front of the barrel come off to remove from the slide or do you need to leave the barrel in the slide for cleaning?
Thanks for any advise you can share.
Tony
I was hoping for a little help. I recently acquired a Beretta 92fs built by David, my question is does the cone at the front of the barrel come off to remove from the slide or do you need to leave the barrel in the slide for cleaning?
Thanks for any advise you can share.
Tony
carman- Posts : 11
Join date : 2019-12-20
Re: David Sams 92fs question
They typically use red loctite on those threads. Leave it alone for cleaning. Break it loose if you need to remove the barrel or replace the locking block.
robert84010- Posts : 787
Join date : 2011-09-21
Re: David Sams 92fs question
It is not meant to be removed unless the gun is to be reworked for accuracy. It is precisely positioned for optimum lockup.
Re: David Sams 92fs question
Do not remove the barrel bushing unless something is broken and needs to be repaired or replaced that requires the removal of the bushing. Absolutely leave it in place. Clean the gun the best you can leaving the barrel in the slide.
Tim:H11- Posts : 1997
Join date : 2015-11-04
Age : 33
Location : Midland, GA
Re: David Sams 92fs question
Thank you all for the information, that's what I was looking for.
Tony
Tony
carman- Posts : 11
Join date : 2019-12-20

» David Sams - Sams Custom Gunworks - M9A1 - NFI
» WTS David Sams M9 "NEW"
» Les Baer 1911 Bullseye OR Rock River Arms 1911 Bullseye
» FS: David Sams Beretta 92
» WTB David Sams .45 Wadgun
» WTS David Sams M9 "NEW"
» Les Baer 1911 Bullseye OR Rock River Arms 1911 Bullseye
» FS: David Sams Beretta 92
» WTB David Sams .45 Wadgun
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum