Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Bullseye-L Forum

A Forum dedicated to the sport of Bullseye shooting


bushing to slide fitment question

2 posters

Bullseye-L Forum :: Equipment Discussion

Go down

bushing to slide fitment question Empty bushing to slide fitment question

Post by Merick 1/27/2022, 1:10 pm

How tight should a bushing flange fit to front face of the slide?

for example

bushing 1; snug (bushing wrench needed to turn) but .003 gap between flange and face of slide

bushing 2; finger tight, except when tab is engaged, (then bushing wrench needed to turn), hard fit of bushing flange to slide face.

which is best?  Or does spring tension make it not matter?

Merick

Posts : 224
Join date : 2015-08-13
Location : Hutchinson Kansas

Back to top Go down

bushing to slide fitment question Empty Re: bushing to slide fitment question

Post by kc.crawford.7 1/28/2022, 7:42 am

Snug fit to ID of slide, flush to front of slide and rear of bushing.
kc.crawford.7
kc.crawford.7

Posts : 658
Join date : 2012-12-09
Location : Maysville, NC

http://www.kcskustomcreations.com

ric1911a1 likes this post

Back to top Go down

Back to top

- Similar topics

Bullseye-L Forum :: Equipment Discussion

 
Permissions in this forum:
You cannot reply to topics in this forum