Ultradot Matchdot II mounting rings
3 posters
Page 1 of 1
Ultradot Matchdot II mounting rings
I'm installing a Matchdot II on a Pardini GT6 in .45 ACP. Is there a suggested torque for the screws?
The manual says to tighten for a snug fit then another 1/4 turn. When I've mounted scopes on my rifles the manufacturers always suggest a minimum and maximum torque for the screws.
The manual says to tighten for a snug fit then another 1/4 turn. When I've mounted scopes on my rifles the manufacturers always suggest a minimum and maximum torque for the screws.
wascanapistol- Posts : 11
Join date : 2022-06-25
Re: Ultradot Matchdot II mounting rings
What size screws? The size dictates the torque.
Wobbley- Posts : 3884
Join date : 2015-02-12
Re: Ultradot Matchdot II mounting rings
I figured it out. 8-32 screws and I torqued them to 17 inch pounds.Wobbley wrote:What size screws? The size dictates the torque.
wascanapistol- Posts : 11
Join date : 2022-06-25
Re: Ultradot Matchdot II mounting rings
It's also possible that these are "angle torque" specs, instead of in-lb. With angle torque, the idea is that the thread ramp causes the fastener to stretch a specific amount, based on the angle it was turned through. In such cases, the fastener is never reused.
However, if the mount doesn't slip or loosen, I'm sure you'll be fine.
However, if the mount doesn't slip or loosen, I'm sure you'll be fine.
-TT-- Posts : 530
Join date : 2016-10-18

» MatchDot II rings vs. LCI mounting rings 30 mm
» FS: Ultradot 30mm Matchdot with rings
» Aimpoint 9000sc Mounting Rings
» Rings for mounting red dot on 1911 slide
» SPF: Like New Clark 41 Barrel, Like New Ultradot Matchdot II w/ Rings
» FS: Ultradot 30mm Matchdot with rings
» Aimpoint 9000sc Mounting Rings
» Rings for mounting red dot on 1911 slide
» SPF: Like New Clark 41 Barrel, Like New Ultradot Matchdot II w/ Rings
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|