Pelican Gun Case
4 posters
Page 1 of 1
Pelican Gun Case
Here is my question of the moment for those shooters that use a pelican case for their gun case. Which model pelican case do you use?
Rob9mmshooter- Posts : 41
Join date : 2013-04-19
Age : 81
Location : Middle TN
Re: Pelican Gun Case
I use a 1500 and although I make it do, it is just a bit too small, so I often end up using a smaller one also and go with two cases. The 1550 would be just right as a single case, but I'm hesitant to go that route, since I have the others in hand and they do work.
Re: Pelican Gun Case
I used the 1510. It does not have the pick foam. It uses velcro dividers. I like the case, Wheels.... Love Wheels.
I use the case for all my hardware and optics. For ammo, net, paperwork, drinks... I have a range bag that goes over my shoulder.
If I'm only shooting 1 gun, I just use the bag. More than 1, they both come out.
I use the case for all my hardware and optics. For ammo, net, paperwork, drinks... I have a range bag that goes over my shoulder.
If I'm only shooting 1 gun, I just use the bag. More than 1, they both come out.
AlexAlphabet- Posts : 29
Join date : 2013-08-23
Location : Wisconsin
Re: Pelican Gun Case
Thanks a lot for the information. Been thinking that I need to use a padded case for the guns with dots. I travel a lot to matches in a 3/4 ton and put the gun box in the back. I have had two Ultradots loose their ability to hold zero and I am starting to think that it is from all the vibration the guns get in the back of the truck. The closest match I go to is 250 miles away.
Rob9mmshooter- Posts : 41
Join date : 2013-04-19
Age : 81
Location : Middle TN
Re: Pelican Gun Case
I use the 1550 box and like it tremendously. In the past I have set it up as a three gun box and currently have it set up as a two gun box. Easy to replace the foam and reconfigure. I attached a scope mount and hinges to keep it open in the wind. I purchased mine from ebay, much cheaper than from an outlet. I have attached some photos.
Jeff
Jeff
Historian1972- Posts : 32
Join date : 2011-12-14
Location : Wichita KS
Re: Pelican Gun Case
One thing I do need to work on is a scope mount. I really do not want to drill into the box as this will ruin the waterproofness.
AlexAlphabet- Posts : 29
Join date : 2013-08-23
Location : Wisconsin
Re: Pelican Gun Case
I placed rubber washers under the bolts for the scope mount, no problems. I am not planning on letting it get wet to the point that I will have to worry about water.
Jeff
Jeff
Historian1972- Posts : 32
Join date : 2011-12-14
Location : Wichita KS
Similar topics
» Travel Gunbox - pelican case?
» Pelican Case for ISSF Pistols
» Pelican Type Case Turned Bullseye Box
» Pelican range box
» .45 ACP Case
» Pelican Case for ISSF Pistols
» Pelican Type Case Turned Bullseye Box
» Pelican range box
» .45 ACP Case
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum