Sig Sauer red dot

Page 2 of 2 Previous  1, 2

Go down

Sig Sauer red dot - Page 2 Empty Sig Sauer red dot

Post by LenV on 3/4/2017, 10:56 pm

First topic message reminder :

Does anyone have any feed back about the Romeo4 or Romeo5? They look like a Aimpoint clone kinda but better then most of the clones. They have some nice features and prices are all over the place. Thanks

Len

http://www.ebay.com/itm/132097618797?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Sig Sauer red dot - Page 2 S-l500
LenV
LenV

Posts : 3639
Join date : 2014-01-24
Age : 69
Location : Oregon

Back to top Go down


Sig Sauer red dot - Page 2 Empty Re: Sig Sauer red dot

Post by PhotoEscape on 4/29/2019, 12:23 pm

TomH_pa wrote:Length of shoulder on the front is .168"-.170" Rear is .095"

Front is somewhat irregular shaped so this dimension is  to the shortest point

Should be fine, - edge to the center of screws is just 0.05".  So it will hold.
AP
PhotoEscape
PhotoEscape

Posts : 423
Join date : 2018-05-15
Location : Northern Illinois, USA

Back to top Go down

Sig Sauer red dot - Page 2 Empty Re: Sig Sauer red dot

Post by Steve Brown on 4/29/2019, 8:26 pm

Are the base and mounting screw pattern the same as the H1?

Steve Brown

Posts : 18
Join date : 2011-06-10
Location : Pacific Northwest

Back to top Go down

Sig Sauer red dot - Page 2 Empty Re: Sig Sauer red dot

Post by Sponsored content


Sponsored content


Back to top Go down

Page 2 of 2 Previous  1, 2

Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum