Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Nelson Mag Question

2 posters

Go down

Nelson Mag Question Empty Nelson Mag Question

Post by Magload 11/1/2017, 1:03 pm

I am shooting a Nelson 22 LR conversion on a Remington R1 frame and would like to mod one mag so the slide does not lock back.  I have done this with a 1911 mag but these mags are not the same.  Any ideas.  I have 6 of these mags so  messing one up is not a biggie. I appears to me that there is a bump on the front right of the follower that could be filed but it also looks like maybe it holds the front of the follower from popping out.  Don
Magload
Magload

Posts : 1173
Join date : 2016-11-18
Age : 77
Location : NE Florida

Back to top Go down

Nelson Mag Question Empty Re: Nelson Mag Question

Post by dronning 11/1/2017, 1:13 pm

Don,
Pull the follower file down the ledge that catches the slide stop.  You might be able to do it without taking it apart but it's easier to clean it.
-Dave
dronning
dronning

Posts : 2581
Join date : 2013-03-20
Age : 70
Location : Lakeville, MN

Back to top Go down

Nelson Mag Question Empty Re: Nelson Mag Question

Post by Magload 11/1/2017, 1:19 pm

dronning wrote:Don,
Pull the follower file down the ledge that catches the slide stop.  You might be able to do it without taking it apart but it's easier to clean it.
-Dave
Thanks Dave I figured that was it but it never hurts to get advice before removing material.  I'm sure I could get another follower anyway.  Don
Magload
Magload

Posts : 1173
Join date : 2016-11-18
Age : 77
Location : NE Florida

Back to top Go down

Nelson Mag Question Empty Re: Nelson Mag Question

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum