Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

22 EIC Match

3 posters

Go down

22 EIC Match  Empty 22 EIC Match

Post by Tim:H11 Tue May 16, 2017 2:54 pm

In the match we're supposed to start with the arm at 45 degrees and raise once time starts (target turns). At what time can I go from resting my arm on the bench to raised at 45 degrees? How long are we hold that for? What are the commands for that match?
Tim:H11
Tim:H11

Posts : 2120
Join date : 2015-11-04
Age : 35
Location : Midland, GA

Back to top Go down

22 EIC Match  Empty Re: 22 EIC Match

Post by Jon Eulette Tue May 16, 2017 3:15 pm

At the final command of 'all ready on the firing line' you have to be off the bench at 45 degrees or less. Unfortunately most benches do not allow 45 degrees because they are too high. Int. pistol used to use small individual shooting benches/tables and getting 45 was no issue.
Jon
Jon Eulette
Jon Eulette

Posts : 4399
Join date : 2013-04-15
Location : Southern Kalifornia

Back to top Go down

22 EIC Match  Empty Re: 22 EIC Match

Post by Tim:H11 Tue May 16, 2017 3:27 pm

Thanks!!!
Tim:H11
Tim:H11

Posts : 2120
Join date : 2015-11-04
Age : 35
Location : Midland, GA

Back to top Go down

22 EIC Match  Empty Re: 22 EIC Match

Post by weber1b Tue May 16, 2017 4:39 pm

You are allowed to have the gun up during the initial commands if you want to set an aim point. The gun then has to be in the down position by "all ready on the firing line". You can start to bring it up as soon as the target starts to turn.

To your question about what are the commands, they are the same. It is only how you position the gun during the commands that has the additional rule vs regular or service pistol matches.

weber1b

Posts : 568
Join date : 2015-10-03
Location : Ballwin, MO

Back to top Go down

22 EIC Match  Empty Re: 22 EIC Match

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum