Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Bullseye-L Forum

A Forum dedicated to the sport of Bullseye shooting


.38SPL brass jam

4 posters

Bullseye-L Forum :: Ammunition Discussion

Go down

.38SPL brass jam Empty .38SPL brass jam

Post by jwax Mon May 31, 2021 6:13 pm

.38SPL wadcutter fired in a S&W Model 52-2- Brass separated at the lower cannulure, and ejected. The other 3/4 inch of brass is stuck in chamber. Looking for ideas on how to extract. It is stuck good (or is it very well?)
Chamber reamer would be nice if I had one.
Ideas? Heat? Solvents? Tricks?
jwax
jwax

Posts : 401
Join date : 2011-06-10
Location : Western NY

http://www.shooterstechnology.com

Back to top Go down

.38SPL brass jam Empty Re: .38SPL brass jam

Post by WesG Mon May 31, 2021 6:47 pm

Oversize bronze brush. Push it in partway, and pull it back out. The reversing bristles should grab it.

WesG

Posts : 468
Join date : 2018-09-21
Location : Cedar Park, TX - N CA

David R likes this post

Back to top Go down

.38SPL brass jam Empty Re: .38SPL brass jam

Post by Kp321 Mon May 31, 2021 7:56 pm

The brush  trick should work. If it does not, buy some Cerrosafe from Brownells and proceed like you were doing a chamber cast. The broken brass will come out with the cast.

Kp321

Posts : 181
Join date : 2019-06-17

Back to top Go down

.38SPL brass jam Empty Re: .38SPL brass jam

Post by Wobbley Tue Jun 01, 2021 12:58 am

The brush trick should work.  Use a 40 or 45 cal brush.

Might want o scrap that brass.
Wobbley
Wobbley

Posts : 3892
Join date : 2015-02-13

Back to top Go down

.38SPL brass jam Empty Re: .38SPL brass jam

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

Bullseye-L Forum :: Ammunition Discussion

 
Permissions in this forum:
You cannot reply to topics in this forum