Star Powder Reservoir Emptying Work Around
Page 1 of 1
Star Powder Reservoir Emptying Work Around
It hit me that emptying the powder from a Star press would be easy, no parts removal required if, as my press is, the press is mounted on an elevated box made of 3/4” plywood. Just add a hinge(s) to one side so the whole top — press attached — can flip over a little past 90 degrees. On the opposite side of the top, add a latch to keep the top locked in place.
Unlatch, remove any primers, remove powder tube lid, place a receptacle to the side, and flip the top over to empty powder into the receptacle.
Something looks different and I can’t figure out how to post a photo. Hmm…
Unlatch, remove any primers, remove powder tube lid, place a receptacle to the side, and flip the top over to empty powder into the receptacle.
Something looks different and I can’t figure out how to post a photo. Hmm…
RodJ- Posts : 907
Join date : 2021-06-26
Location : TX
samtoast likes this post
Re: Star Powder Reservoir Emptying Work Around
Last edited by RodJ on 12/20/2022, 11:06 am; edited 1 time in total
RodJ- Posts : 907
Join date : 2021-06-26
Location : TX
RodJ- Posts : 907
Join date : 2021-06-26
Location : TX
ric1911a1 likes this post
Similar topics
» Star Reloader powder reservoir
» STAR BE 4.2 and 4.4 Powder Slide
» Powder Valley has select Vihtavuori powder on sale
» Star loader adjustable powder bar
» Leaving powder in the powder measure
» STAR BE 4.2 and 4.4 Powder Slide
» Powder Valley has select Vihtavuori powder on sale
» Star loader adjustable powder bar
» Leaving powder in the powder measure
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum