High Standard Gunsmith

That's heartbreaking. 

High Standard Gunsmith
High Standard MT gunsmith services
unsmith with experience on High Standatds in So Cal

Thank you.

Todd

Are the slide rails bent?  Will the slide start onto the frame and then get too tight to go the rest of the way?  Or will it not start at all?

I cannot see the rails on the slide being bent but I cannot get the slide on the frame easily.  I think I bent the corner of the slide when I dropped it on the floor.

Todd

tkleinma wrote:I cannot see the rails on the slide being bent but I cannot get the slide on the frame easily.  I think I bent the corner of the slide when I dropped it on the floor.

Todd

More than likely the rear of the slide bent on one rail. If you have a dial caliper you can measure rails for uniformity. Bending it back can do more harm than good. Might consider having inner rail taken down to refit instead.
Jon

After very close examination with a magnifying glass I found a very small bend in the slide rail.  Using a very small flat file I was able flatten out the bend and the slide now fits perfectly onto the frame!!!!  YAY!!!

Thank you all for your comments.

Todd

You can send your pistol back to the factory and they do fantastic work quickly and within the budget!

http://www.thegunmag.com/repairs-for-high-standard-firearms-and-others/

Turn around was less than two weeks and customer service was fantastic. They did a repair on my pushbutton takedown and an overhaul on all the springs. I was very happy with the service and the price.