Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Need scope base suggestions

2 posters

Go down

Need scope base suggestions Empty Need scope base suggestions

Post by PMcfall Wed Aug 31, 2022 10:14 am

I have a .22 conversion unit that traps brass using the Weaver 60-A base.  I think if I had a base with more height it would cure the problem.  My son has a Victor with a similar base but it is higher (has more thickness), however, I cannot figure out what it is or where to get one like it.  I have relieved the bottom side of the cantilever, but I'm somewhat limited in the amount I can take off and I still have the problem. Suggestions?
Thanks
Phil
Attachments
Need scope base suggestions Attachment
1.jpg You don't have permission to download attachments.(142 Kb) Downloaded 6 times
Need scope base suggestions Attachment
2.jpg You don't have permission to download attachments.(109 Kb) Downloaded 12 times
PMcfall
PMcfall

Posts : 377
Join date : 2011-06-16
Location : St. Joseph, MO

Back to top Go down

Need scope base suggestions Empty Re: Need scope base suggestions

Post by Jon Eulette Wed Aug 31, 2022 10:53 am

Phil,
That’s a ton of clearance. You think it’s actually hitting the ring and then jamming? Use ring with less to hit?
Jon
Jon Eulette
Jon Eulette

Posts : 4399
Join date : 2013-04-15
Location : Southern Kalifornia

Back to top Go down

Need scope base suggestions Empty Re: Need scope base suggestions

Post by PMcfall Wed Aug 31, 2022 10:57 am

I'll take the rear ring completely off and see what happens.
Phil
PMcfall
PMcfall

Posts : 377
Join date : 2011-06-16
Location : St. Joseph, MO

Back to top Go down

Need scope base suggestions Empty Re: Need scope base suggestions

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum