Home
Search
Register
Log inWhat crimp for 9 mm, XTPs and coated?
2 posters
Page 1 of 1
What crimp for 9 mm, XTPs and coated?
by Buck13 2/4/2023, 9:03 pm
I have a Lee taper crimp die. Planning to load some 9 mm cases with HAP125 and coated SWC125. Any suggestions on crimp measurement?
To get the front band under the case mouth, the SWCs will need to be loaded quite a lot deeper than needed to plunk without binding, something like 0.015 or 0.02 shorter.
To get the front band under the case mouth, the SWCs will need to be loaded quite a lot deeper than needed to plunk without binding, something like 0.015 or 0.02 shorter.
Buck13- Posts : 67
Join date : 2018-05-23
Re: What crimp for 9 mm, XTPs and coated?
by tovaert 2/5/2023, 9:48 am
A lot of folks just re-size about .100 down from the case mouth. 9mm is a tapered case.
tovaert- Posts : 423
Join date : 2018-11-28
Similar topics» Crimp with coated bullets
» Roll crimp vs Taper Crimp for Revolver Loads
» 9mm 150 gr Hi-Tek Coated SWC
» 185 grn. coated load
» .45 ACP Coated Bullets
» Roll crimp vs Taper Crimp for Revolver Loads
» 9mm 150 gr Hi-Tek Coated SWC
» 185 grn. coated load
» .45 ACP Coated Bullets
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|